Basic electronics questions and answers

Explain Am And Fm.? Top 10 facts why you need a cover letter? Modulation is the process of varying some characteristic of a periodic wave with an external signals. Passband is the range of frequencies or wavelengths that can pass through a filter without being attenuated. A resistor is a two-terminal electronic component that opposes an electric current by producing a voltage drop between its terminals in proportion to the current, that is, in accordance with Ohm's law:

Uploader: Taumi
Date Added: 27 December 2014
File Size: 25.84 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 71425
Price: Free* [*Free Regsitration Required]





The components of power system may operate at different voltage and power levels. Ranges from 88 to MHz.

Questions and answers on basic electronic components

With an AC source, the SCR will automatically switch to off when the sine wave goes through the zero volts. Different types of communications? The characteristics amplitude, frequency, or andwers of the carrier signal are varied in accordance with the information bearing signal. Analog and digital communication. What is pass band? Electronic switches, switch the rectified DC on and off, and produce a current or voltage waveform at the desired new frequency.

Since most of this range is beyond the vibration rate that most mechanical systems can respond to, RF usually refers to oscillations in electrical circuits or electromagnetic radiation.

How many satellites are required to cover the earth?

What Is An Integrated Circuit? Electronics and Communications Engineering Practice Tests. The transistor is the fundamental building block of computers, and all other modern electronic devices. This tends to increase output.

Diodes have two active electrodes between which the signal of interest may flow, and most are used for their unidirectional current property. As a technology, analog is the process of taking an audio or video signal the human voice and translating it into electronic pulses. Digital signals are immune to noise, quality of transmission and reception is good, components used in digital communication can be produced with high precision and power consumption is also very less when compared with analog signals.

Basic Electronics Questions and Answers | Electrical Academia

Copper is a good conductor of electricity. What are amd characteristics of passive components? What is a repeater? Crosstalk is a form of interference caused by signals in nearby conductors. The main operating characteristic of a diode is that it allows current in one direction and blocks current in the opposite direction.

The BJT is a current amplifier in that a small current flow from the base to emitter results in a larger flow from collector to emitter. A resistor is a two-terminal electronic component that opposes an electric current by producing a voltage drop between its terminals in wnswers to the current, that is, in accordance with Ohm's law:.

Electronics Interview Questions

Name the modulation techniques. The frequency at which the response is -3dB with respect to the maximum response.

Electronic components are the basic building blocks of electronic system or electronic circuit. The content is copyrighted to ElectricalAcademia. Active components depend on the external voltage or current to work.

Electronics Questions and Answers

It is an object intended to support or separate electrical conductors without passing current through itself ; it can vary over that wide range either permanently questionw dynamically. Positive feedback, sometimes referred to as "cumulative causation", is a feedback loop system in which the system responds to perturbation Questionw perturbation means a system, is an alteration of function, induced by external or internal mechanisms in the same direction as the perturbation.

Their main advantages are low cost, low power, high performance, and very small size. List different types of passive components. Explain AM and FM. In contrast, a system that responds to the perturbation in the opposite direction is called a negative feedback system.

Comments 2

Leave a Reply

Your email address will not be published. Required fields are marked *